Advertisement
Available languages
Available languages
30. Before starting operation, make sure that there
is no hidden supply lines such as electric, gas
and water lines under the working surface.
Cutting or damaging the supply lines may cause
electric shock, gas leakage, property damage, or
other accidents.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity
with product (gained from repeated use) replace
strict adherence to safety rules for the subject
product. MISUSE or failure to follow the safety
rules stated in this instruction manual may cause
serious personal injury.
FUNCTIONAL
DESCRIPTION
CAUTION:
Always be sure that the tool is
switched off and unplugged before adjusting or
checking function on the tool.
Switch action
CAUTION:
Before plugging in the tool, always
check to see that the tool is switched off.
To start the tool, slide the slide switch toward the
"I (ON)" position.
To stop the tool, slide the slide switch toward the
"O (OFF)" position.
► Fig.1: 1. Slide switch
Adjusting the orbital stroke rate
The orbital stroke rate is adjustable. To change the
orbital stroke rate, turn the dial between 1 and 5. The
higher the number is, the higher the orbital stroke
rate is. Preset the dial to the number suitable for your
workpiece.
► Fig.2: 1. Dial
NOTE: The dial cannot be turned directly from 1 to 5
or from 5 to 1. Forcing the dial may damage the tool.
When changing the dial direction, always turn the dial
moving it through each intermediate number.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and unplugged before carrying out
any work on the tool.
Installing or removing application
tool
Optional accessory
WARNING:
Do not install application tool
upside down. Installing application tool upside down
may damage the tool and cause serious personal
injury.
WARNING:
Install attachment tool in the cor-
rect direction according to your work. Application
tool can be installed at an angle of every 30
degree.
WARNING:
Always install the application tool
so that the protrusions of the tool flange fit in
the holes on the application tool. Failure to do so
may cause the application tool flown off and result in
personal injury.
WARNING:
When installing the application
tool, be sure to tighten the application tool instal-
lation bolt securely.
Put an application tool (optional accessory) on the tool
flange so that the protrusions of the tool flange fit in the
holes in the application tool and secure the application
tool by tightening the bolt firmly with the hex wrench.
When using sanding application tool, mount the appli-
cation tool on the sanding pad so that it matches the
sanding pad direction.
The sanding pad has a hook and loop type fitting sys-
tem which allows easy and rapid fitting of a sanding
paper.
As sanding papers have holes for dust extraction,
mount a sanding paper so that the holes in a sanding
paper match those in the sanding pad.
To remove a sanding paper, raise its end and peel it off.
Loosen and remove the application tool installation bolt
using a hex wrench and then take off the application
tool.
► Fig.3: 1. Application tool installation bolt 2. Holes
in the application tool 3. Protrusions of the
tool flange
► Fig.4: 1. Application tool installation bolt 2. Hex
wrench 3. Tighten
When using application tools with a different type of
installation section, use a correct adapter (optional
accessory).
► Fig.5: 1. Application tool installation bolt 2. Holes in
the application tool 3. Adapter 4. Protrusions
of the tool flange
7 ENGLISH
Advertisement
