Page 1
MANUAL DE INSTRUCCIONES Lockbolt/Blind Rivet Installation Tool Outil pour boulons de blocage et rivets aveugles Herramienta de instalación para remaches de perno-collar/ remaches ciegos BV4500-118 BV2200-118 IMPORTANT: Read Before Using. IMPORTANT : Lire avant usage. IMPORTANTE: Lea antes de usar.
ENGLISH (Original instructions) SPECIFICATIONS Model: BV4500-118 BV2200-118 Pulling force 20 kN 10 kN Stroke 30 mm (1-3/16") Overall length 358 mm (14-1/8") 290 mm (11-3/8") Rated voltage D.C. 18 V Net weight 2.2 - 2.5 kg (4.8 - 5.5 lbs) 2.1 - 2.4 kg (4.7 - 5.4 lbs)
Page 3
Electrical Safety Do not let familiarity gained from frequent use of tools allow you to become complacent and Power tool plugs must match the outlet. Never ignore tool safety principles. modify the plug in any way. Do not use any adapter plugs with earthed (grounded) power tools.
Page 4
12. Use the batteries only with the products When operating the tool, do not block or seal the ventilation windows of the tool. SAVE THESE INSTRUCTIONS. Symbols CAUTION: Only use genuine Makita batteries. volts direct current charger. 4 ENGLISH...
Tips for maintaining maximum CAUTION: Always install the battery cartridge battery life fully until the red indicator cannot be seen. Charge the battery cartridge before completely discharged. Always stop tool operation and charge the battery cartridge when you notice CAUTION: Do not install the battery cartridge less tool power.
Page 6
Overload protection Pulling force adjustment Overheat protection and "999". NOTICE: For BV4500-118 To break off a mandrel, set the value to "900" or Overdischarge protection higher. When operating the tool without breaking off a mandrel, set the value appropriate for the operation.
Page 7
CAUTION: Do not look in the light or see the source of light directly. releasing the switch trigger. NOTE: charged one. NOTE: Fig.7 (2) Nut B Electric brake NOTICE: When installing the pulling unit (nose center. ASSEMBLY CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool.
For BV2200-118 container Use the tool only for operations that do not break off mandrel. For BV4500-118 cause malfunction of the tool. NOTICE: Be sure to install the mandrel container or the cap to the tool before operating the tool. If...
Fig.13 1. Blind rivet 2. OPTIONAL release the switch trigger. ACCESSORIES CAUTION: These accessories or attachments are recommended for use with your Makita tool Center. Fig.14 NOTE: Installing a lockbolt (without breaking off a mandrel) Fig.15 1. Pin 2. Collar Release the switch trigger and withdraw the tool.