Functional Description - Makita 3706 Instruction Manual

WARNING: DO NOT let comfort or familiar-
ity with product (gained from repeated use)
replace strict adherence to safety rules for
the subject product. MISUSE or failure to fol-
low the safety rules stated in this instruction
manual may cause serious personal injury.
Symbols
The followings show the symbols used for tool.
volts
amperes
hertz
alternating current
no load speed
Class II Construction
revolutions or reciprocation per minute

FUNCTIONAL DESCRIPTION

CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.
Adjusting depth of cut
► 1. Shoe 2. Thumb screw
To adjust the shoe, turn the thumb screw to loosen.
Slide the shoe to the desired position and tighten the
thumb screw securely. Check for the proper clearance
beneath the workpiece before cutting so that the bit will
not strike a hard surface such as the floor, workbench,
etc.
Switch action
1
1. Switch lever 2. Bump off switch
CAUTION:
• Before plugging in the tool, always check to
see that the switch lever actuates properly and
returns to the ''OFF'' position.
• Switch can be locked in "ON" position for ease
of operator comfort during extended use. Apply
caution when locking tool in "ON" position and
maintain firm grasp on tool.
To start the tool, move the switch lever to the ''ON''
position.
To stop the tool, move the switch lever to the ''OFF''
position.
This can be done in the forward area of the switch lever
or by bumping off the rear area of the switch lever.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Installing or removing bit
1
1
2
2
3
► 1. Bit 2. Collet nut 3. Shaft lock 4. Wrench 5. Loosen
6. Tighten
4 ENGLISH
OFF ON
5
6
2
4