Troubleshooting - AEG AFNDA18B Original Instructions Manual

Please read the instructions carefully before
starting the machine.
Always wear goggles when using the machine
Keep hands away
Do not dispose of electric tools together with
household waste material. Electric tools and
electronic equipment that have reached the end of
their life must be collected separately and returned
to an environmentally compatible recycling facility.

TROUBLESHOOTING

PROBLEM
Work-contacting element does not depress
fully - tool does not operate.
Tool operates properly, but fasteners are not
driven fully.
Tool operates properly, but fasteners are driven
too deep.
Tool jams frequently.
Tool stops and LED work lights flash rapidly.
Tool has charged battery and LED work lights
flash slowly.
10
POSSIBLE CAUSE
Nails are low.
Work-contacting element is jammed.
Air pressure is too low.
Depth of drive is not deep enough.
Nail is too long for wood hardness.
Air pressure is too high.
Depth of drive is too deep.
Nails are incorrect.
Nails are damaged.
Magazine is loose.
Magazine is dirty.
Battery is low or has no charge.
Tool is hot.
Tool has malfunctioned.
10
SOLUTION
Replenish the nails.
Remove the battery and clear the debris.
Increase the air pressure.
Adjust the depth of drive.
Use nails of the length that is appropriate for
the wood.
Decrease the air pressure.
Adjust the depth of drive.
Verify that the size of nails is correct.
Replace the nails.
Tighten the screws.
Clean the magazine.
Recharge the battery.
Allow tool to cool.
Take tool to the nearest authorised repair
centre.