Page 2
mportant! It is essential that you read the instructions in this manual before assembling, operating and maintaining the product. Subject to technical modifications.
Page 3
A - No-mar pad B - No-mar pad storage Fig. 4 A - Power adjustment lever B - Mode selector switch (for B16N18 only) C - Belt clip D - LED worklight grip switch E - Trigger switch F - Pusher...
Page 4
Fig. 5 Fig. 8 (for B16N18 only) A - Mode selector switch A - Rear loading magazine B - Full sequential actuation mode B - Nails C - Contact actuation mode C - Nail tips Fig. 9 (for B16N18 only) Fig.
Page 5
Fig. 10 Fig. 12 A - Driver mechanism B - Jam release latch Fig. 13 A - LED worklight grip switch B - LED worklight Fig. 11 A - Elevation screw B - Screwdriver C - Elevation screw cover A - Pusher B - Release button C - Remove nails from the rear of the magazine...
Page 6
AL1218G L1840R L1850R L1860R Use AEG 18V battery and charger only or servicing this tool. Eye protection is required to guard against WARNING! Read all safety warnings and all instructions, flying fasteners and debris, which could cause severe eye injury.
location where the temperature is more than 10°C but less than partially above the workpiece could cause the fastener to miss the 38°C. Do not store outside or in vehicles. workpiece completely and result in serious personal injury. Under extreme usage or temperature conditions, battery Do not drive nails near edge of material.
WARNING WARNING Always remove battery pack from the tool when you are Remove the battery pack from the tool before removing or assembling parts, making adjustments, cleaning, or when not in replacing the no-mar pad. Failure to do so could result in serious use.
Remove battery pack from the tool. battery pack is charged sufficiently and/or if the tool is functioning ■ Slide the selector to position (T) (for B16N18 only). properly. If worklight is flashing, install fully charged battery. If light continues WARNING to flash, see Troubleshooting section for more information.
Use only AEG accessories and AEG spare parts. Should components need to be replaced which have not been described, ■ Remove the battery pack from the tool. please contact one of our AEG service agents (see our list of ■ Remove fasteners from the tool. guarantee/service addresses).
TROUBLESHOOTING PROBLEM POSSIBLE CAUSE SOLUTION Work-contacting element does not depress Nails are low. Replenish the nails. fully - tool does not operate. Work-contacting element is jammed. Remove the battery and clear the debris. Tool operates properly, but fasteners are not Air pressure is too low.