Operation - AEG AFNDA18B Original Instructions Manual

ASSEMBLY
WARNING
Do not use this product if it is not completely assembled or if any
parts appear to be missing or damaged. Use of a product that
is not properly and completely assembled or with damaged or
missing parts could result in serious personal injury.
WARNING
Do not attempt to modify this product or create accessories or
attachments not recommended for use with this product. Any
such alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal injury.

OPERATION

WARNING
Do not allow familiarity with products to make you careless.
Remember that a careless fraction of a second is sufficient to
inflict severe injury.
WARNING
Always remove battery pack from the product when you are
assembling parts, making adjustments, cleaning, or when not in
use. Removing battery pack will prevent accidental starting that
could cause serious personal injury.
WARNING
Always wear eye protection with side shields. Failure to do so
could result in objects being thrown into your eyes, resulting in
possible serious injury.
APPLICATIONS
You may use this product for the purposes listed below:
● Finish and trim (interior and exterior)
● Door & window casing
● Door jambs
● Baseboard
● Crown molding
● Cabinetry
● Cap and shoe molding
● Molding
● Staircases
● Door and window trim
● Chair rail
● Brickmold
● Hardwood flooring
● Panelling
● Furniture
TO INSTALL BATTERY PACK
See figure 2.
Place battery pack in the product. Align raised rib on battery pack
with the groove inside the product.
Make sure the latches on the back of the battery pack snaps in
place and battery pack is secured in the product before beginning
operation.
When placing battery pack in the product, be sure raised rib on
battery pack aligns with the bottom of the product and latches
into place properly. Improper installation of the battery pack can
cause damage to internal components.
TO REMOVE BATTERY PACK
See figure 2.
Locate latches on both sides of the battery pack and depress to
release the battery pack from the product.
Battery tools are always in operating condition. Therefore, switch
should always be locked when not in use or carrying at your side.
NO-MAR PAD
See figure 3.
The no-mar pad attached to the nose of the product helps prevent
marring and denting when working with softer woods.
Remove the battery pack from the product before removing or
replacing the no-mar pad. Failure to do so could result in serious
personal injury.
The pad can be removed by pulling it down and away from the nose.
To replace the pad, fit it into place over the nose and push up at the
back to reseat.
On-board storage for the pad is located on the magazine of the
product. An extra no-mar pad is provided in the on-board storage
area.
LOADING THE PRODUCT WITH NAILS
See figures 4 - 6.
■ Remove the battery pack from the product.
■ Slide the pusher all the way to the rear of the magazine until it
locks in place.
■ With the nose of the product pointed away from you, feed a
strip of nails into the magazine. Be sure the nails are pointed
downward and at the angle shown.
NOTE: The tip of the nails should be parallel to the bottom edge
of the magazine.
NOTE: See figure 4, for acceptable nail sizes.
Keep the product pointed away from yourself and others when
loading nails. Failure to do so could result in possible serious
personal injury.
■ Slide the nail strip as far forward in the magazine as possible.
7
CAUTION
WARNING
WARNING
WARNING
7