Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Baumatic PCG9110SS
Summary of Contents for Baumatic PCG9110SS
- Page 1 PCG9110SS 90cm Single cavity gas cooking theatre bThat...
- Page 3 User Manual for your Baumatic PCG9110SS 90 cm Single cavity gas cooking theatre NOTE : This User Instruction Manual contains important information, including safety & installation points, which will enable you to get the most out of your appliance. Please keep it in a safe place so that it is easily available for future reference;...
-
Page 4: Table Of Contents
Contents Environmental note 5 – 9 Important safety information 9 – 10 Specifications Control panel 12–18 Using your gas cooking theatre Before first use Switching the gas oven on 12–13 Switching the gas grill on 13–14 Using and assembling the rotisserie 14–15 Using the minute minder The oven light... -
Page 5: Environmental Note
Environmental note o The packaging materials that Baumatic uses are environmentally friendly and can be recycled. o Please discard all packaging material with due regard for the environment. -
Page 6: Important Safety Information
Important safety information Your safety is of the utmost importance to Baumatic. Please make sure that you read this instruction booklet before attempting to install or use the appliance. If you are unsure of any of the information contained in this ooklet, please contact the Baumatic Advice Line. - Page 7 This appliance complies with all current European safety legislation. Baumatic do wish to emphasise that this compliance does not remove the fact that the appliance surfaces w become hot during use and retain heat after operation.
- Page 8 o Do not place heavy objects on the oven door or lean on the oven door when it is open, as this can cause damage to the oven door hinges. Nobody should be allowed to sit or stand on any part of the cooker.
- Page 9 Please see the specific section of this booklet that refers to installation. o Baumatic Ltd. declines any responsibility for injury or damage, to person or property, as a result of improper use or installation of this appliance.
-
Page 10: Specifications
o The above directives comply with 93/68/EEC regarding CE marking. o The manufacturer declares that the oven is built using certified materials requires appliance installed accordance with the standards currently in force. This appliance must be used by a trained person for domestic purposes only. Specifications Product dimensions: Height: 870 - 920 mm... - Page 11 Standard accessories: o Enamelled drip tray o Safety shelf o Rotisserie skewer with removable handle o Motorised turnspit o LPG conversion jets o Trivet o Wok stand Optional extras: o BPS1 Pizza stone o BTGRID Double-sided griddle plate Electrical details 230 Vac 50 Hz Rated Voltage: 13 A (double pole switched fused...
-
Page 12: Control Panel
Control Panel Main oven and grill control knob o Use this control knob to light and set the temperature of the main oven. It should also be used to light the grill in the main oven. Hob control knobs o Use these control knobs to light and control the hob burners. -
Page 13: Using Your Gas Cooking Theatre
Using your gas cooking theatre Before first use o To remove any residue from the oven cavity that may have been left from the manufacturing process, you should select the gas oven and set it to its maximum setting. o It is perfectly normal for a smell to be produced during this process. -
Page 14: Switching The Gas Grill On
o Wait for 1 minute, before repeating the ignition procedure again. When lighting the oven for the first time, it may take several times until the electric ignition operates. This is due to there being air in the gas pipe. Switching the gas grill on The grill has electric ignition, to light the grill you should do the following:-... -
Page 15: Using And Assembling The Rotisserie
o IMPORTANT: You should allow the oven to cool completely before attempting to remove the grill deflector. If you attempt to remove the grill deflector before the oven is cool, the deflector will be hot. Using and assembling the rotisserie o Place the food on the spit (L);... -
Page 16: Using The Minute Minder
o To rotate the spit in the opposite direction, whilst wearing a protective oven glove, turn the rotation knob (A). o Make sure that you press the rotisserie on/off button, and then turn the main oven control knob to 0 before attempting to remove the spit (L). -
Page 17: Cooking Guidelines
Cooking guidelines o Please refer to the information given on food packaging for guidance on cooking temperatures and times. Once familiar with the performance of your appliance, temperatures and times can be varied to suit personal preference. o Preheat the oven for at least 15 minutes before placing food into the cavity. -
Page 18: Using The Hob Top
Using the hob top The following symbols will appear on the control panel, next to each control knob: Black circle: gas off Large flame: maximum setting Small flame: minimum setting o The minimum setting is at the end of the anti-clockwise rotation of the control knob. -
Page 19: Energy Saving Tips
Energy saving tips o The diametre of the bottom of the pan should correspond to that of the burner. o The burner flame must never extend beyond the diametre of the pan. o Use flat bottomed pans only o When possible, keep a lid on the pan whilst cooking. o Cook vegetables with as little water as possible, to reduce cooking times. -
Page 20: Cleaning And Maintenance
Any damage that is caused to the appliance by a cleaning product will not be fixed by Baumatic free of charge, even if the appliance is within the guarantee period. -
Page 21: Cleaning The Hob Burners
Cleaning the hob burners The hob burners should be cleaned once a week or more frequently if they get soiled. o Remove the hob burners by pulling them upwards and away from the hob top. o Soak them for about ten minutes in hot water and a little detergent. -
Page 22: Removing The Oven Doors For Cleaning
Removing the oven door for cleaning o Open the oven door fully. o The hinges (A) are provided with two movable hooks (B). o Rotate the hooks into the slot (C). o You should grip the sides of the door at the centre and then incline it slightly towards the oven cavity and then by pulling it gently away from the oven cavity. -
Page 23: Installation
Installation The installation must be carried out by a suitably qualified person, in accordance with the current version of the following. o UK Regulations and Safety Standards or their European Norm Replacements. o Building Regulations (issued by the Department of the Environment). - Page 24 (including the burners). o Baumatic do not recommend that the cooker is positioned below wall cupboards, as the heat and steam from the appliance and what is being cooked, may damage the cupboard and its...
-
Page 25: Gas Connection
Conversion for use on LPG and other gases must only be undertaken by a qualified person. For information on the use of other gases, please contact the Baumatic Technical Department. o The cooker must be installed by a qualified person, in... -
Page 26: Ventilation Requirements
o In the UK, GASSAFE registered installers are authorised to undertake the installation and service work, in compliance with the above regulations. Ventilation requirements o The room containing the cooker should have an air supply in accordance with the current edition of BS 5440: Part 2: o The room must have opening windows or equivalent;... -
Page 27: Gas Safety (Installation And Use) Regulations
Gas Safety (Installation and Use) Regulations o It is the law that all gas appliances are installed by competent persons in accordance with the current edition of the Gas Safety Installation and Use Regulations. o It is in your interest and that of safety to ensure compliance with the law. - Page 28 o IMPORTANT: THE FIBRE WASHERS SHOWN IN THE ABOVE DIAGRAM MUST BE IN PLACE WHEN CONNECTING THE ADAPTOR ELBOW. o Connection to the cooker should be made with an approved appliance flexible connection to BS 669. o If the cooker has been converted for use with LPG, then it should be connected to the gas supply using an appropriate bayonet type hose.
-
Page 29: Gas Adjustment (Conversion To Lpg For The Hob Top)
Gas adjustment (Conversion to LPG for the hob top) work must carried GASSAFE registered engineer. IMPORTANT: Always isolate the cooker from the electricity supply before changing the injectors and/or adjusting the minimum flow of the burners. o Remove the pan-stands, burners and flame spreaders (A). -
Page 30: Minimum Flow Adjustment For Hob Gas Taps
* In reference conditions, gas temperature 15°C, atmospheric pressure 1013.25 mbar o Reassemble all the burners carefully; in particular you should make sure that the flame spreader is correctly placed on the burner. o IMPORTANT: After changing the injectors YOU MUST follow the minimum flow adjustment section below. -
Page 31: Gas Adjustment (Conversion To Lpg For The Oven And Grill)
Gas adjustment (Conversion to LPG for the oven and grill) work must carried GASSAFE registered engineer. IMPORTANT: Always isolate the cooker from the electricity supply before changing the injectors and/or adjusting the minimum flow of the burners. o Free the burners from their fixing screws. -
Page 32: Minimum Flow Adjustment For The Oven And Grill Burners
IMPORTANT: After changing the injectors YOU MUST follow the minimum flow adjustment section below. Minimum flow adjustment for the oven and grill burners work must carried GASSAFE registered engineer. o Light the burner and set the knob at the minimum position. o Remove the knob from the tap and place a small bladed screwdriver into the screw that’s to the side of... -
Page 33: Fitting A Stability Chain
Fitting a stability chain IMPORTANT: It is a legal requirement for your GASSAFE registered installer to fit a stability chain. The stability hook should be securely fixed to the fabric of the building, in an adjacent position to the safety chain at the rear of the appliance. The chain should be kept as short as is practical. -
Page 34: Electrical Connection
Electrical connection This appliance must be installed by a qualified person in accordance with the latest edition of the I.E.E. Regulations and in compliance with Baumatic’s instructions. WARNING: THIS APPLIANCE MUST BE EARTHED. o Before connecting the appliance, make sure that the supply voltage marked on the rating plate corresponds with your mains supply voltage. -
Page 35: Connecting The Mains Supply Cable
Connecting the mains supply cable IMPORTANT The wires in the mains lead are coloured in accordance with the following code: GREEN AND YELLOW EARTH BLUE NEUTRAL BROWN LIVE o Open the mains terminal block cover as shown, unscrew the cable clamp (A) and unscrew (not fully) the screws in the mains terminal block (L, N, E) which secure the three wires of the mains cable. -
Page 36: My Appliance Isn't Working Correctly
o The “blue” neutral wire must be connected to the terminal marked with letter (N) - the live wire must be connected to the terminal marked with letter (L). My appliance isn’t working correctly The gas oven burner or grill burner do not light. * Check that the oven is switched on at your mains supply. - Page 37 Or any installation other than the one specified by Baumatic Ltd. has been completed. Please refer to the conditions of guarantee that appear on the warranty card that you receive with the appliance.
-
Page 38: Contact Details
Czech Republic United Kingdom Baumatic CR spol s.r.o. Baumatic Ltd., Průmyslová zóna Sever 696 Baumatic Buildings, 460 11 Liberec 11 6 Bennet Road, Czech Republic Reading, Berkshire RG2 0QX +420 483 577 200 United Kingdom www.baumatic.cz Sales Telephone (0118) 933 6900...