Table of Contents
Advertisement
Programming
Canadian Option
Pressing 1 while viewing System Setup Screen #3 will configure the FACP to comply with
Canadian requirements. The display will change to Canadian Opt. On. Each press of the 2 key will
cause the display to toggle between Canadian Opt. On and Canadian Opt. Off. The factory default
setting is Canadian Opt. Off.
The Canadian Options configures the FACP with the following as required by Canada:
•
•
•
•
•
SYSTEM SETUP
1=CANADIAN OPTION
2=SEC ANN ENABLE
Secondary ANN-BUS Option
System Setup Screen #3
Pressing 2 while viewing System Setup Screen #3 allows the user to enable the secondary
ANN-BUS. The secondary ANN-BUS must be enabled if any modules are connected to the
ANN-SEC option card at J13. To enable the Secondary ANN-BUS, press 1 while viewing the
SEC-ANN screen so that the display reads SEC ANN Enabled Yes. Each press of the 1 key will
cause the display to toggle between SEC ANN Enabled Yes and SEC ANN Enabled No. The factory
default setting is ANN-SECONDARY Enabled No.
3.5.7 ANN-BUS
Optional ANN-BUS devices available for the FACP include annunciators, relay modules and
ROGRAMMING
1=ANN-BUS
printer connection for acquiring hardcopy printouts of panel data. Pressing 1 while viewing
2=HISTORY
Programming Screen #3 will cause the control panel to display the following screens.
3=WALKTEST
Programming Screen #3
An ANN-S/PG Printer module, ANN-80 LCD annunciator module and an ANN-RLY relay module
can be programmed in the FACP. These devices communicate with the FACP over the ANN-BUS
terminals on the control panel.
ANN-BUS Enabled
The ANN-BUS must be enabled if any modules are installed on the ANN-BUS terminals. To
enable the ANN-BUS, press 1 while viewing ANN-BUS screen #1 so that the display reads ANN-
BUS Enabled Yes. Each press of the 1 key will cause the display to toggle between ANN-BUS
Enabled Yes and ANN-BUS Enabled No.
66
The following zone type codes are not available:
non-latching supervisory
non-latching drill
Any allowed zone type programmed as Auto-Resettable will be changed to latching version of
that zone type (N.O. Contact AR will be changed to N.O. Contact, Combo with AR
Supervisory will be changed to Combo, 2-wire Heat AR will be changed to 2-wire Heat, Low
Pressure AR will be changed to Low Pressure, High Pressure AR will change to High Pressure
and Supervisory AR will change to Supervisory).
The auto-silence feature will be disabled by the panel.
The installer must write in the Date of Final Assembly on the Master Marking and Warranty
label, located on the FACP backbox door.
When the ANN-80C LCD Canadian indicator is installed: Local Silence button will silence
annunciator piezos, Lamp Test button will perform an annunciator lamp test, pressing and
holding Sounder Test button will sound annunciator piezo, pressing step up/down arrows will
scroll through stored events. These buttons may be enabled or disabled by programming.
ANN-BUS
1=BUS ENABLED
2=BUS MODULES
3=AUTO CONFIGURE
ANN-BUS Screen #1
1=ANN-S/PG OPTIONS
NO
2=ANN-80 OPTIONS
3=ANN-RLY OPTIONS
ANN-BUS Screen #2
MRP-2001 Series Manual — P/N 53040:H 1/26/2017
Master Programming Level
ANN-BUS
Advertisement
Table of Contents
