Honeywell IdentIPoint Quick Installation Manual page 7

Honeywell IdentIPoint Intelligent Smartcard Readers
Fig.5. Routing the wires before plugging the connectors
into the reader
CLIP ROUND FERRITE CLIP ON CLIP ROUND FERRITE CLIP ON
THE FIELD ETHERNET CABLE THE FIELD ETHERNET CABLE
WITH TWO TURNS WRAPPED WITH TWO TURNS WRAPPED
ROUTE THE RJ45 CONNECTOR ROUTE THE RJ45 CONNECTOR
(IF REQUIRED) AND MOLEX (IF REQUIRED) AND MOLEX
TERMINALS FROM BEHIND THE TERMINALS FROM BEHIND THE
DRYWALL OR THROUGH THE DRYWALL OR THROUGH THE
CONDUITS (IN CASE OF CONDUITS (IN CASE OF
CONCRETE WALL) AND BRING CONCRETE WALL) AND BRING
THEM TOWARDS THE FRONT THEM TOWARDS THE FRONT
SIDE OF THE MOUNTING SIDE OF THE MOUNTING
SURFACE THROUGH THE SURFACE THROUGH THE
OPENING ON THE READER'S OPENING ON THE READER'S
BACK-PLATE. BACK-PLATE.
PLUG THE RJ45 CONNECTOR PLUG THE RJ45 CONNECTOR
INTO THE ETHERNET PORT OF INTO THE ETHERNET PORT OF
THE READER AT THE END OF THE READER AT THE END OF
THE PIGTAIL. THE PIGTAIL.
PLUG THE MOLEX TERMINALS PLUG THE MOLEX TERMINALS
INTO THE J9 AND J10 PORTS INTO THE J9 AND J10 PORTS
OF THE READER OF THE READER
7
95-7771