Advertisement
Honeywell IdentIPoint Intelligent Smartcard Readers
3. Route the field wires from the conduits into
the gang-box and bring them inside the
IOM via the knock-out holes.
4. The IOM can now be mounted on the wall.
Hold the back half in position over the
gang-box and wall. Align the three
mounting screws with their holes and
fasten the back half securely on the gang-
box and wall using the screws. See Fig.14.
5. Connect the wire terminals to the ends of
the wires and plug the wire terminal(s) in
their correct slots on the PCB. See Fig.15.
For IOM connection details see Fig.17.
Accommodate any excess wire lengths
inside the gang-box. Set the S1 DIP switch
if the IOM is to be connected to a reader
via RS485. See Fig.17 and appendix for
more details.
6. Set the IOM address as per Fig.17 and
appendix. Once all connections and
settings are done, close the IOM enclosure
by pressing the front case cover over the
back half. See Fig.15.
7. Use the Allen wrench to tighten the tamper-
resistant screw at the top of the IOM
enclosure. See Fig.16.
95-7771
12
Advertisement
