Detailed Operating Modes; Functional Modes; Off - Honeywell BENDIX KING KT 73 Installation Manual

Preliminary - Subject To Change Without Notice
BENDIX/KING
(c) Category set "C" code:
0
1
2
3
4-7 Reserved
(d) Category set "D" code:
0
1-7 Reserved
OTHER:
Reserved for factory use only.
3.3

DETAILED OPERATING MODES

3.3.1

FUNCTIONAL MODES

The functional mode is selected by the mode select switch, see the display below. The following
modes are available.
(a)

OFF

(b) SBY (Standby)
(c) GND (Ground)
(d) ON (On)
(e) ALT (Altitude)
(f) FLT ID (Flight ID)
(g) TST (Test)
OFF:
The unit is not energized. When the unit is in the OFF mode the Backlighting will be illuminated if
either the 14 VDC or 28 VDC lighting bus has power applied.
When the unit is powered up (switched from the OFF position to another mode) the following will
occur:
(a) The unit will reply and/or squitter according to the selected mode within two (2) sec-
onds.
(b) The display will show the information associated with the mode that it is in.
Rev 0, October/2002
No ADS-B Emitter Category Information
Surface Vehicle - Emergency Vehicle
Surface Vehicle - Surface Vehicle
Fixed Ground or Tethered Obstruction
No ADS-B Emitter Category Information
10563I00.JA
KT 73
Page 3-9