Operation; Programming Mode; Kt 73 Front Panel - Honeywell BENDIX KING KT 73 Installation Manual

Preliminary - Subject To Change Without Notice
BENDIX/KING
3.1 GENERAL
Section 3 describes the operation of the KT 73. Where applicable, illustrations of the displays are
furnished to assist the operator in understanding the operation of the unit and also provide a visual
aide for programming sequences. Figure 3-1 illustrates the various panel controls and displays of
the unit.
3.2

PROGRAMMING MODE

The programming mode is entered using the following procedure:
(1) Place the unit in Standby mode.
(2) Select 0000 ident code.
(3) Simultaneously depress the IDT and VFR buttons for a minimum of 2 seconds.
To select the programming mode menu, rotate the cursor (CRSR) knob either clockwise or
counter clockwise to advance either up or down, respectively, through the following menu options
and then depress the IDENT button.
(1) A/C ADDR
(2) MAX AIR
Rev 0, October/2002
SECTION III

OPERATION

NOTE:
The KT 73 and all other avionics, should be turned
off before starting the aircraft engine(s).
FIGURE 3-1 KT 73 FRONT PANEL
NOTE:
While in the programming mode, the KT 73 will not
transmit RF energy.
(Aircraft Address)
(Maximum Airspeed)
10563I00.JA
KT 73
Page 3-1