Honeywell BENDIX KING KT 73 Installation Manual page 74

Preliminary - Subject To Change Without Notice
BENDIX/KING
(3) ALT SRC
(4) ENH FUNC
(5) ENH FUNC
(6) AUTO GND
(7) AIR VOL
(8) GND VOL
(9) ADSB EMT
(10) OTHER
Upon completing the programming of the KT 73, power down the unit. The settings chosen are
now stored in the unit's internal memory and configuration module.
For a listing of the above menus and their respective sub-menus, refer to figure 3-2 on the follow-
ing page. To navigate the programming menu and sub-menus depicted in figure 3-2, use the fol-
lowing procedure:
(1) Rotate the CRSR knob to move across the major headings.
(2) Press the IDT button to select a particular heading option.
(3) Rotate the cursor (CRSR) knob to cycle between choices.
For example, when ALT SRC is selected as the major heading option, the CRSR
knob is rotated to cycle between the following choices:
429 (706)
RS-232
Gillham
If the RS-232 sub-menu option is selected, three sub-options may also be selected
by first pressing the IDT button and then rotating the CRSR button. They are listed
below:
8800M (Shadin Models compatible with UPS AT, formerly IIMorrow)
8800G (Shadin Models compatible with Magellan)
8800T (Shadin Models compatible with Trimble)
In summary, the CRSR knob cycles between heading choices. Once a given choice is displayed,
the IDT knob selects it and moves the cursor to the next major heading. In this case, the cursor
would move from ALT SRC to ENH FUNC (Gillham Selected).
Rev 0, October/2002
(Altitude Source Select)
(Enhanced function when Gillham altitude source is selected)
(Enhanced function when ARINC 429 or RS-232 altitude source is
selected)
(Automatic on ground determination)
(Audio volume while in the air)
(Audio volume while on the ground)
(ADS-B emitter category)
(Reserved for Factory Only)
10563I00.JA
KT 73
Page 3-2