Makita DTD136 Instruction Manual page 9

High tensile bolt
N m
120
(kgf cm)
(1,224)
100
(1,020)
80
(816)
60
(612)
40
(408)
20
(204)
0
Fastening time (S)
009219
Model DTD147
Standard bolt
N m
(kgf cm)
140
(1,428)
120
(1,224)
100
(1,020)
80
M12
(816)
60
(612)
M10
40
(408)
M8
20
(204)
0 1.0
Fastening time (S)
012775
High tensile bolt
200
(2,040)
180
(1,836)
160
(1,632)
140
(1,428)
120
(1,224)
100
(1,020)
80
(816)
M8
60
(612)
40
(408)
20
(204)
0 1.0
012774
Hold the tool firmly and place the point of the driver bit in
the screw head. Apply forward pressure to the tool to the
extent that the bit will not slip off the screw and turn the
tool on to start operation.
M12
(M12)
M10
(M10)
M8
(M8)
3.0
1.0 2.0
M16
M14
(M16)
(M14)
(M12)
(M10)
(M8)
2.0 3.0
M14
M12
M10
2.0 3.0
Fastening time (S)
NOTE:
Use the proper bit for the head of the screw/bolt
•
that you wish to use.
When fastening M8 or smaller screw, choose a
•
proper impact force and carefully adjust pressure
on the switch trigger so that the screw is not
damaged.
Hold the tool pointed straight at the screw.
•
If the impact force is too strong you tighten the
•
screw for a time longer than shown in the figures,
the screw or the point of the driver bit may be
overstressed, stripped, damaged, etc. Before
starting your job, always perform a test operation
to determine the proper fastening time for your
screw.
The fastening torque is affected by a wide variety of
factors including the following. After fastening, always
check the torque with a torque wrench.
1. When the battery cartridge is discharged almost
completely, voltage will drop and the fastening
torque will be reduced.
2. Driver bit or socket bit
Failure to use the correct size driver bit or socket
bit will cause a reduction in the fastening torque.
3. Bolt
•
•
4. The manner of holding the tool or the material of
driving position to be fastened will affect the
torque.
5. Operating the tool at low speed will cause a
reduction in the fastening torque.
MAINTENANCE
(M14)
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
(M12)
perform inspection or maintenance except for the
following troubleshooting related to the light.
(M10)
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
(M8)
result.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.
9
Even though the torque coefficient and the
class of bolt are the same, the proper
fastening torque will differ according to the
diameter of bolt.
Even though the diameters of bolts are the
same, the proper fastening torque will differ
according to the torque coefficient, the class of
bolt and the bolt length.