Makita DTD136 Instruction Manual
Cordless impact driver
Hide thumbs
Also See for DTD136:
- Instruction manual (68 pages) ,
- Instruction manual (65 pages) ,
- Instruction manual (68 pages)
Related Manuals for Makita DTD136
Summary of Contents for Makita DTD136
- Page 1 INSTRUCTION MANUAL Cordless Impact Driver DTD136 DTD147 012567 IMPORTANT: Read Before Using.
-
Page 2: Specifications
• Due to our continuing program of research and development, the specifications herein are subject to change without notice. • Specifications and battery cartridge may differ from country to country. • Weight, with battery cartridge, according to EPTA-Procedure 01/2003 END004-4 Model DTD136 Symbols The following show the symbols used for the equipment. Sound pressure level (L ) : 94 dB (A) Be sure that you understand their meaning before use. -
Page 3: General Power Tool Safety Warnings
(grounded) power EC Declaration of Conformity tools. Unmodified plugs and matching outlets will We Makita Corporation as the responsible manufacturer reduce risk of electric shock. declare that the following Makita machine(s): Avoid body contact with earthed or grounded... - Page 4 may result in serious personal injury. 23. Use the power tool, accessories and tool bits Use personal protective equipment. Always etc. in accordance with these instructions, wear eye protection. Protective equipment such taking into account the working conditions as dust mask, non-skid safety shoes, hard hat, or and the work to be performed.
-
Page 5: Functional Description
rules for the subject product. FUNCTIONAL DESCRIPTION MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. ENC007-7 CAUTION: IMPORTANT SAFETY Always be sure that the tool is switched off and the •... - Page 6 Overloaded: • 1. Button The tool is operated in a manner that causes it to draw an abnormally high current. In this situation, release the trigger switch on the tool and stop the application that caused the tool to become overloaded. Then pull the trigger switch again to restart.
- Page 7 Changing the impact force 1. Changed in four steps 2. Hard 3. Medium 4. Soft 5. T mode 6. Button 012609...
- Page 8 Maximum blows Impact force grade Application Work displayed on panel DTD136 DTD147 Hard Tightening when force Tightening in underwork 3,400 3,200 and speed are desired. material/ Tightening long (min ) (min ) screws/ Tightening bolts. Medium 2,800 2,600 Tightening when a good...
- Page 9 • even with a recharged battery cartridge, cool down the tool fully. If the status will not change, stop using and have the tool repaired by a Makita local service center. 011406 To install the bit, pull the sleeve in the direction of the ASSEMBLY arrow and insert the bit into the sleeve as far as it will go.
-
Page 10: Operation
Model DTD136 NOTE: If the bit is not inserted deep enough into the sleeve, • Standard bolt the sleeve will not return to its original position and the bit will not be secured. In this case, try (kgf cm) (1,224) re-inserting the bit according to the instructions above. -
Page 11: Maintenance
If you need any assistance for more details regarding • screw for a time longer than shown in the figures, these accessories, ask your local Makita Service Center. the screw or the point of the driver bit may be Screw bits •... - Page 12 Makita Corporation Anjo, Aichi, Japan www.makita.com 885251A220...