Advertisement
CARE AND MAINTENANCE
Cleaning the Burner Assembly
– Make sure the grill is cool
1. Turn gas off at the control knobs and LP gas cylinder.
2. Disconnect LP gas cylinder from regulator and hose.
3. Remove warming rack, cooking grates and heat tents.
4. Detach burner by removing the cotter pins at the back of the burners to detach them from the brackets.
5. Detach ignition wire from electrode by hand only. DO NOT use pliers or any other tool as it may damage
the electrode or wire.
6. Lift burner slowly.
7. Ensure all burner ports are clear of clogs. Use of a pin or paper clip works well.
8. Ensure burner is free of any damage. If damage is found, replace it with new burner.
9. Ensure the end of the burner and primary air screen are clear from insect nests, dirt or debris.
Re-installing the Burner
urner inlet (venturi).
osition.
ox vent holes as illustrated below.
Reattach each burner with the hinge pin and reattach the ignition wire to electrode.
Bottom View
Wrong
Wrong
Correct
View the correct position
WARNING
may result, possibly
causing serious bodily injury or death.
Other Care and Maintenance
It is recommended that inspection and service on this appliance
service person.
It is recommended that you always check that the outdoor cooking appliance area is clear and free
nd liquids before lighting.
ustion and ventilation air are not
obstructed.
It is recommended that you regularly check that the ventilation openings of the grill cabinet
are free and clear from debris.
It is recommended that you regularly check and clean the burner/venturi tubes for insects and insect
19
Advertisement
