Pbxware Version; Installation; Power Adapter; Find The Phone's Ip Address - Cisco 8851 User Manual

PBXware Version

PBXware version 5.3.8
In order to find out the PBXware version:
Log in to PBXware
Navigate to Settings: About.
On the top of About page is a code similar to this one Edition: Multi-Tenant, Release:
5.3.8.0 (2223ce45), Running: 13.23.1-gc-040bbaca, Proxy v5.3.8 (231c5f3), API: 5.3,
libmemcached version: 1.0.18, where Release denotes the current version of your PBXware.

Installation

This section describes how to install and connect the phone to the electrical power and data
network as well as how to apply factory settings.
The following topics are covered:

Power Adapter

Factory Settings
Power Adapter
Connect the Network and Power
Connect the DC plug on the power adapter to the DC port on the phone and connect the other
end of the power adapter into an electrical power outlet.
Connect the Ethernet cable between the Internet port on the phone and the network port on a
router or switch to access LAN.

Find the Phone's IP Address

Find out your Cisco phone's IP Address
Press the Settings button
Type 72 to check the phone's IP address
IP address should be displayed on the phone.

Reset to Factory Settings

This step is not required for brand new out-of-the-box phones, however, if the phone has been
already used, then it is a must.
Press the Settings button
Type 65
Confirm with OK to factory reset the phone