Table of Contents
Advertisement
1. Enter the administrator password and press the [Enter] key.
The settings saved in this product are returned to their factory-set state, SYSLOG is deleted
and then the product reboots.
5.5.2. Entering the [I] (uppercase I) key during startup to restore the
factory settings
The product can be restored to its factory settings by entering an uppercase "I" when the product is
starting up. Here we explain how to reboot the product using the "reload" command. The procedure is
also the same when rebooting by pulling out the power cord and plugging it back in again.
Memo
• This explanation assumes that you have logged in using the steps in
from a computer connected to the CONSOLE
1. Type "enable", and press the [Enter] key.
You are now in privileged EXEC mode.
SWX2320>enable
SWX2320#
2. Enter the "reload" command, and press the [y] key.
The product will reboot.
SWX2320#reload
reboot system? (y/n): y
3. After reboot, enter an uppercase "I" within one second after the "BootROM Ver" (see below)
appears on the console screen.
SWX2320 BootROM Ver.1.00
Memo
• Before the "BootROM Ver" appears on the console screen, you can press the
[Caps Lock] key or hold down the [Shift] key so that you will be ready to enter
an uppercase "I" immediately.
4. When you see a screen asking whether to execute initialization, press the [y] key to execute.
Initialize or not ?(y/n)
Initialization is executed.
Ready to Initialize
...............
port".
L2 SWITCH SWX2320-16MT User Guide | 35
5. Settings
"Logging in
Advertisement
Table of Contents
