Digicom LEONARDO56 User Manual page 27

LEONARDO 56
AT&V VIEW ACTIVE AND STORED PROFILES
AT&W STORE ACTIVE PROFILE
&W0 Store active profile as Profile 0.
&W1 Store active profile as Profile 1.
AT&Y DEFINE DEFAULT PROFILE AFTER POWER ON
&Y0 Use profile 0 after power on.
&Y1 Use profile 1 after power on.
AT&Z STORE THE X TELEPHONE NUMBER IN A N LOCATION
AT&Zn =X (n = from 0 to 3; X = dialing string from 0 to 35 numbers).
AT\A MNP BLOCK SIZE
\A0 Block size 64 chr.
\A1 Block size 128 chr.
\A2 Block size 192 chr.
\A3 Block size 256 chr.
AT\B BREAK SIGNAL SIZE
\B1 to \B9 In non-error corrector mode, the modem will trasmit a break signal
to the remote modem with a lenght in multiples of 100 ms according
parameter specified. The command works in conjunction with the
\K command. In error corrector mode, the modem will signal a
break through the active error correction protocol, giving no
indication of the length.
AT\KN SET BREAK CONTROL
Controls the response of the modem to a break received from the DTE or the
remote modem or the \B command according to the parameter supplied. The
response is different in three separate states.
1) The first state is where the modem receives a break from the DTE
when the modem is operating in data transfer mode.
\K0 Enter on-line command mode, no break sent to remote modem.
\K1 Clear data buffer and send break to remote modem.
\K2 Same as 0.
\K3 Send break to remote modem immediatly.
\K4 Same as 0.
\K5 Send break to remote modem in sequence with trasmitted data.
2) The second case is where the modem is in the on-line command
state (waiting for AT commands) during a data connection, and the
\B is received in order to send a break to the remote modem.
Modem AT Command Set
3.9