Digicom LEONARDO56 User Manual page 21

LEONARDO 56
I3 Product name
I4 Firmware release
I5 Country Code active
ATL SPEAKER VOLUME
L1 Low speaker volume.
L2 Medium speaker volume.
L3 High speaker volume.
ATM SPEAKER CONTROL
M0 Speaker always off.
M1 Speaker on until carrier is detect.
M2 Speaker always on.
M3 Speaker off during dialing and on until carrier is detect.
ATN AUTOMODE ENABLE
N0 Automode detection is disabled (equivalent to setting AT+MS=X,0).
N1 Automode detection is enabled (equivalent to setting AT+MS=X,1).
Note: see also "AUTOMODE" parameter in AT+MS command
ATO RETURN ON LINE
O0 On line state when during connection the modem is in command
mode.
O1 Like previous plus equalaizer retrain.
ATP SET PULSE DIAL DEFAULT
This command forces pulse dialing.
ATQ QUIET RESULT CODES
Q0 Display result codes.
Q1 No result code (quiet).
ATS READ/WRITE A REGISTER
Sn=x Write value x to S Register n.
Sn? Read value at S Register n.
ATT SET TONE DIAL DEFAULT
This command forces tone DTMF dialing.
ATV VERBOS RESULT CODE
V0 Result code display as digit (short form).
V1 Result code display as words (extention form).
Modem AT Command Set
3.3