Digicom LEONARDO56 User Manual page 20

LEONARDO 56
ATB CCITT/BELL Mode
B0 CCITT mode.
B1 Bell Mode.
ATD Dial Command
0:9 Dial number
* DTMF digits
# DTMF digits
A-D* DTMF digits
P pulse dial
T tone dial
S=n Dial one of the four stored phone numbers (n=0-3) in the
modem non volately memory (See &z Command)
! flash
W wait for dial tone
@ wait for five seconds of silence
, pause
L recall the last number dialed
; return to Command state. Added to the end of the dial string, this
causes the modem to return to the command state after it
processes the portion of the dial string preceding the ";". The
modem will enter call progress only after an additional dial
command is issued without the ";" terminator.
^ Toggle calling tone
ATE Commands Echo
E0 Commands echo disable.
E1 Commands echo enable.
ATF Select Line Modulation
This command is supported only for compatibility. No function is performed.
Refer to +MS command to select modulation.
ATH DISCONNECTION
H0 Modem disconnects
H1 Modem connects to the line and remain in command mode
for the time defined in S7.
ATI IDENTIFICATION
I0 Maximum line speed
I1 Product type
I2 Checksum firmware
Modem AT Command Set
3.2