Advertisement
DEFROSTING
Defrosting occurs fully automatically in the
refrigerator compartment during normal operation.
The defrosted water collected by the evaporating tray
evaporates automatically.
NOTE: The evaporating tray & water drain hole
should be cleaned periodically with a plastic
straw to prevent water from collecting on the
bottom of the refrigerator instead of flowing out.
TIPS FOR ENERGY SAVINGS
Try not to open the door too often, especially when
the weather is wet and hot. Once you open the
door, be sure to close it as soon as possible.
Use higher thermostat settings only if essential
and not for constant, long-term use.
Before loading the appliance with packages of
fresh foods, ensure they are cooled to an ambient
temperature (except in the case of soup).
Ice and frost layering will increase energy
consumption, so defrost & clean the appliance as
soon as the layer is 3-5mm thick in your icebox.
If the door seal (gasket) is damaged, the energy
consumption will be much higher. To keep the
sealing in good condition, be sure not to spill oils
or fats on it. A damaged seal will need to be
replaced. Make sure that if you have reversed the
door, you fluff out the crushed side of the seal with
a hairdryer before reinserting it.
The condenser at the back of the appliance must
always be clean and free of excessive dust.
13
Hide quick links:
Advertisement
