General Reading Instructions; Ga - Get Active; Gt - Get Tag - AEG ARE DT1 Installation Manual

Note: The function VS shows just the settings that are used in the actual ISO standard.
1
just available in the ISO 14443A standard
2
just available in the ISO 15693 standard
3.4

General reading instructions

3.4.1 GA – get active
The command GA causes one reading cycle. There are different cycles for different transpondertypes.
This command is only available in the ISO 14443A standard.
Mifare 4 byte UID:
Mifare 7 byte UID:
The reader answers the UID of an active (non halt) transponder.
Input format:
Output (example):
3.4.2 GT – get tag
With the command GT you select a transponder. The command GT causes one reading cycle. There
are different cycles for different transpondertypes.
Mifare 4 byte UID:
--------------------------------------------------------------------------------21/45--------------------------------------------------------------------------------
...
request (REQA)
anticollision
select
request (REQA)
anticollision level 1
select 1
anticollision level 2
select 2
GA <CR>
625E562A <CR>
request (WUPA)
anticollision
select