Kl - Keyboard Language - AEG ARE DT1 Installation Manual

Output (example):
Parameter:
PARAMETER
0
1
You have to unplug the device and plug the device in again to use the new setting. Don't forget to use the
command VSAVE to save the new setting.
If the reader is in HID mode, you can not send any commands to the device. Because of that you have to
use the Set-Up card – interface to switch the reader back from HID mode to serial interface mode.
1. Plug out the reader
2. Place card no reader
3. Plug in reader into USB-port
4. Wait for the beep tone from reader
5. Plug out reader
6. Remove card from reader
3.2.4 KL – keyboard language
With the command KL you can configure the language of the keyboard in HID mode.
Input format:
Output (example):
Parameter:
PARAMETER
07
--------------------------------------------------------------------------------12/45--------------------------------------------------------------------------------
0 <CR>
FUNCTION
RS232 emu-
lation
HID inter-
face, key-
board
KL <SP> parameter <CR>
07 <CR>
FUNCTION
german