Step 5: Configure the network settings
To set the time and date:
1. In the Start menu, click Control Panel .
2. In the Control Panel window under Clock, Language, and Region , click Set
the time and date
3. In the Date and Time window, click Change date and time... .
4. In the Date and Time Settings window , select the date on the calendar
and then click OK .
5. In the Date and Time window, click Change time zone... .
6. In the Time Zone Settings window, select the UTC time zone from the
dropdown and then click OK .
Step 5: Configure the network settings
Configure the network settings for your environment using the Control
.
Panel
Step 6: Register the edge device
After you change the built-in administrator password, you can register the
edge device with HCP Anywhere. Once an edge device is registered, it
appears in the HCP Anywhere Management Console on the Device
Management
Important: Make sure that you have network access to the HCP Anywhere
server before registering the edge device.
Note: To register an edge device:
•
You need to authenticate with an AD user. HCP Anywhere does not
support registering an edge device with a SAML user.
•
In your HCP Anywhere profile, you need to have the edge device type
enabled. For information on enabling the edge device type in a profile,
see the HCP Anywhere Administrator Help .
28
HCP Anywhere Edge Appliance On-Site Setup and Recovery
.
page.
Chapter 3: Configuring the HCP Anywhere edge appliance