Removing/Installing The Cabinet; Upper Case Assembly; Rear Assembly; Front Assembly - Sony IPELA SNC-CS11 Service Manual

1-4. Removing/Installing the Cabinet

1-4-1. Upper Case Assembly

Removal
1. Remove the lens. (Refer to Section 1-3.)
2. Remove the seven screws, then remove the upper case
assembly.
1BSW M2 x 5
2BSW M2 x 5
Installation
3. Attach the upper case assembly.
4. Attach the three screws 1.
5. Attach the four screws 2.

1-4-2. Rear Assembly

1. Remove the lens. (Refer to Section 1-3.)
2. Remove the upper case assembly.
(Refer to Section 1-4-1.)
3. Remove the three screws.
4. Disconnect the harness from the connector (CN901)
on the CN-2861 board, then remove the rear assembly.
1-2
1BSW M2 x 5
Upper case
assembly
5. Attach the rear assembly in the reverse order of steps 1
2BSW M2 x 5

1-4-3. Front Assembly

1. Remove the lens. (Refer to Section 1-3.)
2. Remove the upper case assembly.
3. Remove the screw, then remove the harness (with lug
4. Remove the four screws.
5. Remove the dowel A of the front chassis from the
6. Disconnect the flexible flat cable from the connector
7. Attach the front assembly in the reverse order of steps
Harness
BSW M2 x 5
BSW M2 x 5
to 4.
(Refer to Section 1-4-1.)
terminal) from the lower case assembly.
hole A of the SY-339 board, then remove the front
assembly in the direction of the arrow.
(CN101) on the SE-849 board.
Flexible flat cable
Dowel A
BSW M2 x 5
Hole A
Front chassis
BSW
M2 x 5
CN101
Front assembly
SE-849 board
1 to 6.
CN901
Rear assembly
CN-2861 board
SY-339 board
Lower case
assembly
BSW
M2 x 5
Harness
(with lug terminal)
SNC-CS10/CS11