Board; Cn-2861 Board - Sony IPELA SNC-CS11 Service Manual

1-5-3. PS-720 Board
Removal
1. Remove the lens. (Refer to Section 1-3.)
2. Remove the upper case assembly.
(Refer to Section 1-4-1.)
3. Remove the rear assembly. (Refer to Section 1-4-2.)
4. Remove the SY-339 board. (Refer to Section 1-5-1.)
5. Disconnect the harness (with lug terminal).
(Refer to step 4 of Section 1-4-3.)
6. Remove the PR-297 board. (Refer to Section 1-5-2.)
7. Remove the four screws, then remove the PS-720
board in the direction of the arrow.
8. Disconnect the two harnesses from the connectors
(CN801 and CN802) on the PS-720 board.
PS-720 board (Side A)
4
2
Hole A
CN802
PS-720 board
1-4
3
1
Harnesses
CN801
BSW
M2 x 5
Dowel A
Lower chassis
Installation
9. Connect the two harnesses to the connectors (CN801
and CN802) on the PS-720 board.
10. Install the PS-720 board, then align the dowel A of the
lower chassis with the hole A of the PS-720 board.
11. Attach the four screws in the order of 1, 2, 3 and 4.
12. Assemble this unit in the reverse order of steps 1 to 5.

1-5-4. CN-2861 Board

1. Remove the lens. (Refer to Section 1-3.)
2. Remove the upper case assembly.
(Refer to Section 1-4-1.)
3. Remove the rear assembly. (Refer to Section 1-4-2.)
4. Remove the two screws.
5. Remove the two hooks of the rear panel assembly,
then remove the CN-2861 board.
Boss
CN-2861 board
Hole
BTP2.6 x 6
Hole
6. Install the CN-2861 board in the reverse order of steps
1 to 5.
n
Check that the two bosses of the rear panel assembly
are securely inserted into the two holes of the CN-
2861 board, then attach the two screws.
Rear panel assembly
Boss
Hooks
SNC-CS10/CS11