Color Reproduction Adjustment; Procedure After Completion Of Overall Sy-339; Adjustment - Sony IPELA SNC-CS11 Service Manual

6. Check that the position of the luminescent spot is in
the center of the color reproduction frame using the
vectorscope.
n
If the position of the luminescent spot is not in the
center of the color reproduction frame, perform the
white balance adjustment again.

2-2-4. Color Reproduction Adjustment

1. Shoot a color-bar chart using this unit.
2. Click the [Start|color|reproduction] button.
2-6
The luminescent spot has to
cover the center of the color
reproduction frame.
3. Set the lens iris to 65IRE.
4. Check the position of the luminescent spot using the
vectorscope, and adjust the value of "F-90 to 95" so
that the luminescent spot is in the center of the color
reproduction frame.
. F-90: Adjust the widening in the up and down
directions.
. F-91: Adjust the widening in the left and right
directions.
. F-92: Move the right half portion up and down.
. F-93: Move the left half portion up and down.
. F-94: Move the upper half portion left and right.
. F-95: Move the lower half portion left and right.
n
The position of the luminescent spot after the value is
changed can be checked by clicking the [Send]
button.
F-93: Left half, up and down
5. After completing the adjustment, click the
[Finish|color|reproduction] button.
2-2-5. Procedure after Completion of Overall

Adjustment

1. Click the [OK] button on the adjustment window, then
quit the adjustment program.
2. Disconnect each device from this unit.
F-92: Right half, up and down
F-94: Upper half,
left and right
F-95: Lower half, left and right
F-90: Widening in the up and
down directions
F-91: Widening in the left and
right directions
SNC-CS10/CS11