Honeywell IF1C User Manual page 13

4. Connect a USB cable from the RFID reader to your desktop PC.
5. When the USB Driver Installation Wizard appears, click Browse my computer
6. In Search for driver software in this location, click Browse, select the folder
7. Click the Windows icon > Control Panel > Device Manager and see which COM
8. Click Next to install the drivers.
9. If you are using Windows 8 or Windows 10 operating system, a warning may be
10. When the installation is finished, click Close.
11. Open a serial communications program to connect to the reader.
12. Type config and press Enter, and then type config again in the Password
13. By default, DHCP is enabled and the IP address to configure the reader
14. If you are not using DHCP, press D. DHCP is disabled and the Ethernet
6
for driver software.
where you extracted the reader installation files, and click OK.
port the reader was assigned.
displayed. Click on Install this driver to proceed with the installation.
field and press Enter.
appears. Use the IP address to configure the reader through the web browser
interface.
Configuration Options screen appears.
IF1C Fixed RFID Reader User Guide