Makita N5900B Technical Information page 8

R
epair
< 6 > Separating base from motor section
( 1 ) Remove safety cover as illustrated in Fig. 2 and Fig. 3 in page 2/9 before the step in Fig. 23.
( 2 ) Take off ring spring 12 from lever 54. Remove lever 54 together with hex nut M8 from cap square neck
bolt M8x90. See Fig. 23 and Fig. 24.
( 3 ) Take off cap square neck bolt M8x90 from blade case. The rear side of motor section has been disconnected
from base in this step. See Fig. 24.
( 4 ) Unscrew hex nut M6-10 and remove
pan head screw M6. See Fig. 25.
The motor section has been disconnected
from base completely. See Fig. 26.
Hex nut M8
Lever 54
Fig. 25
Cap square
neck bolt M8x90
Pipe 9
Pan head screw M6
Hex nut M6-10
Lever 54
Flat washer 8
< Note >
Be careful, not to lose flat washer 8 which is
mounted between pipe 9 and depth guide of
base, when removing cap square neck bolt M8x90.
Fig. 24
Base
Fig. 26
P 8 / 9
Ring spring 12
Fig. 23