Honeywell DR Graphic recorder Installation Instruction page 3

4. Push the door handle out by using the wrench and pull out the latch door handle by your other hand. Remove the
latch CAM and Southco spring assembly.
Fitting New Door Handle
5. Insert C shaped washer on top of the door handle. The flat surface of c shaped washer should be on the bottom
6. Insert latch spring into the stud. Make sure that the smaller radius end of the spring is facing stud head.
43-TV-33-217 iss.3 GLO Jan 2021 UK
Figure 3 — Removing both the hex nuts
Figure 4
Adding C shaped washer
Figure 5
Latch spring and stud
3