Initial Start-Up; Positioning The Charging Station; Installing The Boundary Wire - Grizzly MR 400 Translation Of The Original Instructions For Use

• Keep the charger clean and
away from wet and rain. Do not
use the charger outdoors. Dirt
and the entry of water increase
the risk of electric shock.
• Operate the charger only with
the appropriate original batteries.
Charging other batteries may
result in injuries and risk of fire
• Avoid mechanical damage to
the charger. This can result in
internal short circuits.
• Do not operate the charger on
a combustible surface (e.g. pa-
per, textiles).Risk of fire due to
heating during charging.
• If the power cable for this
equipment is damaged, it must
be replaced by the manufac-
turer, a customer service agent
of the same or a similarly quali-
fied person in order to prevent
hazards.
• Do not attempt to charge non-
rechargeable batteries in the
charger. The device could get
damaged.

Initial start-up

Regularly check the lawn area for
rocks, branches, wires and other
objects that may damage the de-
vice and the blades.
Make sure that the mowing zones
for two or more automatic lawn
mowers are placed at a sufficient
distance (at least 2.5 - 3 m) from
each other.
If mowing zones are too close to
each other, this can cause the de-
vices to malfunction.
Positioning the charging
station
1. Select a flat position near a socket for
the charging station (12) with at least
2 m of space in front and 1 m behind.
2. Secure the charging station and the
charging station bumper (12b) with the
fixing nails (8).
The charging station bumper (12b)
is fastened to the side of the charg-
ing station outside the restricted lawn
area.
The working range indicator (12a) on
the charging station must be located
within the restricted lawn area.
3. Connect the charging station to the
charger (10) using the connectors
(9+13). Ensure that the connector
contacts marked with "1" and "2" are
engaged correctly.
Make sure that the charging sta-
tion (12) is positioned an adequate
distance away from ponds, pools
and steps.
We recommend installing a roof for
the charging station (12) to protect
it from weather damage.
Installing the boundary
wire
Before starting up the automatic lawn
mower, the boundary wire (6) must be
placed around the lawn area to be cov-
ered by the automatic lawn mower.
You can do this as follows:
- Mark out the lawn area with the hooks
(7).
- Bury the boundary wire (6) in the
ground (max. depth of 5 cm).
GB
89