Updating The Firmware; Storage; Storage Over Winter; Transport - Grizzly MR 400 Translation Of The Original Instructions For Use

Replacing the blades
3. Remove the old blades (23).
4. Refasten the new blades (23) with the
blade bolts (24).

Updating the firmware

Firmware updates can be performed by
one of our service partners (see "Service
Centre").

Storage

• Store the device in a dry place, out of
reach of children.
• Do not enclose the device in nylon
sacks as this may cause moisture to
form.
We are not liable for damage cause by
our devices if this is caused by improper
repair, the use of non-original parts or in-
correct use.

Storage over winter

• Clean the device prior to storage (see
"Cleaning and maintenance").
• Make sure that the on/off switch (5) on
the device is set to "Off".
• Only store the batteries in the partially-
charged state. The charge status
should amount to 40-60% during a
lengthy storage period.
• Check the battery charge status ap-
proximately every 3 months during a
lengthy storage period and recharge if
necessary.
• Disconnect the charging station from
the boundary wire
• Insulate the contacts of the boundary
wire with adhesive tape
If you are starting the device after
an extended storage period, clean
the battery contacts on the device
and the charging prongs (26) on the
charging station with a brass brush
to prevent charging problems.

Transport

A carrying handle (4) for transporting the
device is located on the rear of the auto-
matic lawn mower.
Always carry the automatic
lawn mower with the blades (23)
pointing away from your body.
Risk of injury!
Disposal/environmental
protection
Remove the battery from the device and
recycle the device, battery, accessories
and packaging in an environmentally-
friendly manner.
Electrical devices do not belong in
domestic waste.
Do not throw batteries into domes-
tic waste, fire (risk of explosion)
or water. Damaged batteries can
harm the environment and your
health if poisonous fumes or liq-
uids escape.
• Hand the device and the charger to a
recycling point. The plastic and metal
parts used on your device can be
properly sorted according to materials
and grades and efficiently recycled.
Please contact our service centre for
more information.
GB
95