Honda BF35A Service Manual page 378

B F40AoBF50A
CONTROL CABLES, UNDER COVER
Install the cable holder as shown noting the installation
direction and tighten the 6 x 12 mm bolt washer to the
specified torque.
TORQUE: 0.7 Nom (0.7 kgfom, 5.1 Ibfa)
Apply grease to the link pins of the throttle arm and
shift arm, then connect the throttle cable and shift
cable.
Set the shift cable by aligning the groove of the cable
with the cutout of the mounting point.
Set the throttle cable by aligning the groove with the
cutout of the cable holder.
Route the throttle and shift cable through the grommet
(upper hole: shift cable, lower hole: throttle cable) holes
and set the grommet in the case correctly.
Power trimhilt type only:Check whether the power tilt
switch wire does not interfere with the throttle cable.
Tighten the cover screw to the specified torque.
TORQUE: 2.2 N*m (0.22 kgfom, 1.6 Ibf*ft)
[ l ] SCREW (6)
I
2.2
N*m
I
[9] 4 mm E-CLIP ( 2 ) -
181
THROTTLE ARM
-
\
A
[7] SHIFT ARM
161
GROMMET
/
15-21