Honda BF35A Service Manual page 356

2) After installing the power trim/tilt assembly, tighten
the 7/8-14 UNF self-locking nut to the specified
torque. Then turn it back 1/2
-
3/4 turns.
TORQUE: 39 N*m (4.0 kgfom, 29 Ibfoft)
3) Route the power trim/tilt motor and trim angle sensor
wires and secure them with the clips.
11
1
7/8-14 UNF SELF-
LOCKING NUT,
I
[ l ] WIRE HARNESS CLIP
Clamp the trim angle sensor wire
together with the power trimhilt
switch wire and power trimhilt relay
wires as shown.
[2] PURSE LOCK CLIP
trim/tilt switch wire, power
trimhlt relay wires, and trim
151
TRIM ANGLE SENSOR
WIRE
[3] POWER TRIMITILT'
/ - - A /
I
MOTOR WIRE
[3] POWER TRIMITILT
[9] 14 mm TUBE CLIP
MOTOR WIRE
141
((
TRIM ANGLE SENSOR
Clamp the center of the gray tape
position of the power trimhilt motor
wire with the wire harness cliD.
,
I
SPIRAL PROTECTOR
angle sensor wires, wrap the
wires between the 14 mm
TRIM ANGLE SENSOR
POWER TRIMITILT
MOTOR WIRE
[6] MOTOR CORD BUSHING
WIRE
13-1 0