Honda BF35A Service Manual page 283

BF40AoBF50A
Toraue
Note
Thread dia. x pitch
Item
Nsm kgf-m Ibf*ft
Extension/Mount
Steering friction lever nut
(Long tiller handle type)
Lower motor mount housing bolt
M8 x 0.75
M8 x 1.25
9.5
22
0.95
2.2
6.9
16
Stern bracket
Stern bracket left side nut
Stern bracket right side nut
7/8-14UNF
M10 x 1.25
39
34
4.0
3.5
29
25
Tiller handle
Steering bracket pivot lock nut
Steering bracket pivot nut
Steering bracket nut
Throttle arm holder bolt
Throttle grip bolt
Under cover screw
Cable holder bolt
Emergency stop switch nut
Connector bracket bolt
Throttle cable pivot lock nut
Switch bracket bolt
M12 x 1.25
M12 x 1.25
MlOx 1.25
M5 x 0.8
M6 x 1
.O
M5 x 0.8
M5 x 1
.O
M16x 1.0
M6 x 1 .O
M6 x 1 .O
M5 x 0.8
54
29
34
4.5
7
2.2
7
1.3
7
1.3
4.5
5.5
3.0
3.5
0.45
0.7
0.22
0.7
0.13
0.7
0.13
0.45
40
22
25
3.3
5.1
1.6
5.1
0.9
5.1
0.9
3.3
Gas assisted damper
Tilt lever nut M6 x 1 .O 6.5 0.65
4.7
NOTE:
Apply oil to the thread and seating surface.
Tighten to the specified torque first, then tighten an additional 90"- 120".
Clean off oil or grease from the crankshaft and flywheel mating surfaces (see page 6-1). Apply oil to the
thread and seating surface of the flywheel bolt, then tighten them to the specified torque.
If the split pin cannot be set by tightening the castle nut to the specified torque, tighten the castle nut addi-
tionally until the split pin can be set. Do not exceed the maximum torque of 34 N-m (3.5 kgf-m, 25 Ibf-ft).
If the tab of the washer does not align with the groove of the gear case end nut by tightening it to the speci-
fied torque, tighten the castle nut additionally until the groove aligns with the tab. Do not exceed the maxi-
mum torque of 98 Nem (10.0 kgf-m, 72 Ibf-ft).
Turn the friction lever to the right side fully, and hold it in this position and tighten the friction lever nut to the
specified torque.
Tighten the stern bracket nut to the specified torque, then turn it back to 180
-
210".
2-2