Using A Self Assembled Connecting Cable; Assembling Of The Cable Pipe; Mounting Of The Cable - AEG AMP 4 Installation Manual

2.4.4 Using a self assembled connecting cable

Using the following SAB cabs you can assemble your own connecting cable.
ID 70211
ID 70215
ID 70219
You can use any shielded five-pole cable. The allowed diameter of the cable must be in the range
from 3,5 to 8mm. For this case, IP 65 is reached.
Attention!
The minimum voltage at the readers input mustn't be lower then 9V.
The maximum length of the serial RS232 cable is 15m.

2.4.4.1 Assembling of the cable pipe


Breakthrough the prepared areas at the surface of the SAB Cabs. There are two prepared areas seen
at the SAB Cab: central and at one side of the cab.

The o-ring (3) has to be assembled proberly to the cable pipe (4) to ensure the protection class IP
65.
2
Figure 2 Assembling of the cable pipe

Bring the nut (2) of the cable pipe inside of the SAB Cab (1).

To fasten the nut please use the right tool (17mm).

2.4.4.2 Mounting of the cable

The cable must be mounted in following steps:
--------------------------------------------------------------------------------7/20--------------------------------------------------------------------------------
SAB cab with 1 PG9 cable pipe
SAB cab with 2 pre-assembled cable pipes
SAB cab without any cable pipe
4
3
1