Trouble Shooting; Replacement Parts/Accessories - Grizzly MR 1000 Translation Of The Original Instructions For Use

GB

Trouble Shooting

Problem
Device does not
start
Engine switches
off
Device rotates
incessantly on
the lawn area
Output not satis-
factory or engine
is difficult to op-
erate
Abnormal
sounds, clatter-
ing or vibrations

Replacement parts/Accessories

Spare parts and accessories can be obtained at
If you do not have internet access, please contact the Service Centre (see "Grizzly
Sercice-Center").
98
Possible cause
On/Off switch (
"Off" ("0" position)
Rechargeable battery not in-
serted
Defective motor
Grass too long
Blockage by foreign body
Boundary wire (
damaged
Cutting height too low
Blades ( 26) blunt
Blade area blocked
Blades ( 26) incorrectly as-
sembled
Blade bolts ( 27)
loose
Blades damaged (
www.grizzly-service.eu
Troubleshooting
Set the on/off switch (
5) set to
"On" (position "1") (see "Switch-
ing on and off")
Insert rechargeable battery (see
"Replacing the rechargeable bat-
tery")
Send the device in to the Service
Centre for repair
Pre-mow the lawn area if neces-
sary.
Set higher cutting height.
Remove foreign body
6) cut or
Repair the boundary wire (
Set higher cutting height
Sharpen or replace blades
Clean device
Install blades correctly
Tighten blade bolts
26) Replace blades
5) to
6)