Trouble Shooting; Repair Service - Grizzly ERM 1333 G Translation Of The Original Instructions For Use

Repair Service

• Repairs, which are not covered by
the guarantee, can be carried out for
charge by our service center. Our ser-
vice center will be glad to provide you
with a cost estimate. We can only pro-
cess devices which have been packa-
ged sufficiently and which have been
dispatched with correct stamping.

Trouble Shooting

Problem
Equipment does not
start
Motor stops
Result unsatisfactory or
motor labours
Blade fails to turn
Strange noises, rattling
or vibrations
Possible Cause
Power is off
Defective on/off switch
Worn carbon brushes
Defective motor
Grass too long
Blockage by foreign ob-
ject
Cut height too low
Blade blunt
Blade area blocked
Blade assembled incor-
rectly
Blade blocked by grass
Blade screw loose
Blade screw loose
Blade damaged
• Note: In case of complaint or service,
please deliver your device cleaned,
and with an indication of the defect, to
our service address.
Devices sent in freight collect - by
bulk freight, express or with other
special freight - are not accepted.
• Defective units returned to us will be
disposed of for free.
Fault Fixing
Check the socket, cable, wire
and plug and have any repairs
carried out by an electrician
Repair by customer services
Set a greater cut height. Lift the
front wheels slightly by pressing
down on the handle bar
Remove the foreign object
Set a higher cut height
Have the blade sharpened or
replace it
Clean the equipment
Install the blade correctly
Remove the grass
Tighten the blade screw
Tighten the blade screw
Replace the blade
GB
41