Connecting The Boundary Wire To The Charging Station; Switching On And Off; Settings; Setting The Language - Grizzly MR 1000 Translation Of The Original Instructions For Use

Narrow passages
Narrow passages on the bordered lawn
area should be at least 1.2 m wide and no
more than 8 m long (see figure
Connecting the boundary
wire to the charging
station
1. Strip approx. 10-15 mm of the end of the
boundary wire (6) using cable strippers.
2. Pass the "start" of the boundary wire
(6) under the charging station (12)
and connect this to the contact jack
(30) marked with "+".
3. Connect the "end" of the bound-
ary wire (6) to the contact jack (31)
marked with "S1".
Allow a metre of additional space
for corrections when installing the
boundary wire (6).
Do not place the "protruding"
remains of the boundary wire
together. This can lead to faults
and failures in the automatic lawn
mower's operation.

Switching on and off

Switching the automatic lawn mower on
1. Press the on/off switch (5) on the un-
derside of the automatic lawn mower
(position "1").
2. Press the power key (17) on the LCD
display's control panel.
The LCD display (23) is illuminated.
Switching the automatic lawn mower off
3. Press the on/off switch (5) on the un-
derside of the automatic lawn mower
(position "0").
If the factory settings are not adequate for
your situation, the automatic lawn mower
m ). has the following options, which you can
set using the control panel (15).

Setting the language

1. Open the cover on the LCD display
2. Unlock the LCD display (23) with the
3. Use the arrow keys (20) to select the
4. Use the arrow keys (20) to navigate
5. Use the arrow keys (20) to select the
6. Return to the main menu with the

Changing the PIN

1. Open the cover on the LCD display
2. Unlock the LCD display (15) with the
3. Use the arrow keys to select the
4. Enter the old 4-digit PIN and confirm
5. Enter a new 4-digit PIN and save this
6. Return to the main menu with the

Settings

(2).
4-digit PIN. This is set to "1-2-3-4" ex-
factory.
"General settings" symbol and
confirm the selection with the
OK key (22).
to "Language" (third option of the 4
selection options) and confirm the se-
lection with the OK key (22).
desired language and confirm the se-
lection with the OK key (22).
back key (21).
(2).
4-digit PIN. This is set to "1-2-3-4" ex-
factory.
"Change PIN symbol" and con-
firm the selection with the OK key.
this with the OK key.
with the OK key.
back key (21).
GB
91