Sony PCM-D100 Help Manual page 171

Help Guide | Synchronizing recording with playback (Digital Synchronized Recording)
3. Press
The "Digital SYNC REC" is set to "ON." ("Digital SYNC REC" is set to "OFF" by
default.)
4. Press the HOME/BACK button.
The stop mode display appears again.
5. Slide the INPUT switch to the "LINE" position.
6. Perform recording operation in the same way as when using the built-in microphones
to set the linear PCM recorder to recording standby mode.
7. Start playback on the external device.
Recording starts automatically with track information from the connected external
device. When a new file is played back, recording also starts as a new file.
Note
When a different digital signal is input, it is recorded as a new file because different
signals cannot be saved in the same file.
During digital recording, the counter display might be approximately one second later
than the actual recording.
During digital recording from a CD/MD/DAT player, the linear PCM recorder may fail to
record in synchronized recording mode depending on the type of source data or
operations attempted.
Operation cannot be guaranteed for all types of CD/MD/DAT players. Some external
devices may not operate properly.
During digital recording, the following features cannot be used:
MIC ATT switch
Recording level setting
LIMITER setting
Recording mode setting
LCF(Low Cut) setting
SBM(Super Bit Mapping) setting
pre-recording
S/N 100dB
Digital recording may be disabled when the remaining available recording time is less
file:///C/...ers/1000025409/Desktop/HTML_PDF%20Files/Help_4475418131_PCMD100_EN/4475418131.w/en/contents/TP0000225962.html[8/1/2019 8:20:45 AM]
or to select "ON," and then press the button.
166