Honeywell CIU 888 Troubleshooting And Maintenance Manual page 38

Error Message
No new firmwares found
Not a valid firmware file
Failed to perform upgrade firmware
from R101.6 to R103 and CIU System
status/ Ring of light turns to RED indi-
cating a Fatal failure.
No license is available
Invalid license is available
Updating license failed
Operation failed. Retry after opening
configuration and W&M key switches
2 - 12
Software Troubleshooting and Error Messages
Possible cause
USB flash drive inserted into front
USB port of CIU 888 does not contain
any firmware files to install.
Firmware copied to USB flash drive is
not firmware from Honeywell Enraf.
Disturbance during upgrade firmware,
for example, power failure.
View license option was selected in
Web interface without installing
license.
License file within CIU 888 is corrupt.
Failure while updating license to
CIU 888.
Search firmware option was selected
during firmware upgrade operation
while Configuration lock and W&M
lock key switches were in 'closed'
position.
License was installing while Configu-
ration lock and W&M lock key
switches were in 'closed' position.
Troubleshooting & Maintenance Guide
CIU 888
Solution
1. Copy firmware files that need to
be installed on CIU 888 to USB
flash drive (not inside any folders).
2. Retry operation.
Note: Refer to the Firmware Upgrade
Manual CIU 888 (Part No. 4417596)
for more information.
1. Copy firmware provided by
Honeywell Enraf to USB flash
drive.
2. Retry operation.
Note: Refer to the Firmware Upgrade
Manual CIU 888 (Part No. 4417596)
for more information.
Check whether the firmware version
of CIU 888 after restart is R101.6. If
yes, perform the firmware upgrade
again.
Refer to Firmware Upgrade Manual
CIU 888 (Part No. 4417596) for more
information.
1. Install license on CIU 888.
2. Repeat the operation.
Refer to Firmware Upgrade Manual
CIU 888 (Part No. 4417596) for more
information.
1. Install license on CIU 888.
2. Repeat the operation.
Refer to Firmware Upgrade Manual
CIU 888 (Part No. 4417596) for more
information.
1. Install valid license.
2. Repeat operation.
Refer to Firmware Upgrade Manual
CIU 888 (Part No. 4417596) for more
information.
1. Open Configuration lock and
W&M lock key switches.
2. Repeat operation.
Part No.: 4417594_Rev11