Table of Contents
Advertisement
Available languages
Available languages
GB
Putting the telescopic arm to-
gether:
1. Put both parts of the telescopic
arm (18) together and tighten the
screw.
Make sure that the cable is not
clamped.
Assembling/dismantling the
telescopic arm:
2. Push the device along the guide
rail (
holder (24) of the telescopic arm.
It locks into place audibly.
3. To dismantle, pull the device out
of the holder (24) with moderate
force.
Adjust the height of the tel-
escopic arm
Adjust the length of the telescopic
arm for your size with the help of
the adjusting screw (19).
Adjusting the working angle
For a comfortable edge cut, the equipment
holder (24) of the telescopic arm can be
rotated to the right or left.
Set the desired position by pulling
the release switch (22) and rotating
the equipment holder (24) of the tel-
escopic arm. The equipment holder
locks into the desired position when
the release switch is released.
94
11) into the equipment
Switching on and off
(with telescopic arm)
1. Remove the blade guard (
14/17) before switching the de-
vice on.
2. Insert the safety key (
the device.
3. To switch on, hold the switch
lock (20) on the handle of the
telescopic arm and simultane-
ously press the on/off switch
(21). Release the switch lock,
device runs at top speed.
4. To turn it off, release the on/off
switch (21).
Working with the telescopic
arm
•
Slowly push the device on the wheels
over the floor. By doing so, you will
achieve an even cutting height.
Cleaning/Maintenance
Leave any work not covered in
this manual to our Service Cen-
tre. Only use original parts. There
is a risk of injury!
Ensure that the safety key (
is removed before all tasks.
Never use cleaning agents or sol-
vents, which can cause irreparable
damage to the unit. Chemicals can
attack the plastic components on
the unit.
Wear gloves when handling the
blades (
of injury from cuts!
6) into
13/15). There is a risk
6)
Advertisement
Chapters
Table of Contents
