AEG ITE42600KB User Manual page 9

Use only a special heat-
resistant silicone.
The worktop cutout
Distance minimum 50 mm
from the
wall
Length 490 mm
Width the sum of all widths of appli-
ances that you install minus
20 mm
Example:
+ -
360 mm 360 mm
Assembly
• Calculate correct cutout dimensions.
• Prepare the worktop cutout.
• Place the appliances on a soft surface
(e.g. a blanket) with the bottom side
up.
• In the case of the Teppan Yaki, attach
the supplied seal stripe to its lower
edge, along the outer edge of the
glass ceramic. Loosely screw the
fixing plates into the correct holes in
the protection casing.
• Insert the first appliance into the
worktop cutout. Mount the
connection bar under the appliance
so that a half of its width is still visible
- it will support the next appliance.
• For the Teppan Yaki, loosely screw in
the fixing plates to the worktop from
=
20 mm 700 mm
below (at the front and the rear of the
appliance).
• Insert the next appliance into the
worktop cutout. Make sure that the
front edges of the appliances are on
the same level.
• Fix appliances other than Teppan Yaki
with the use of snap-in springs.
• At the end, tighten the screws of the
Teppan Yaki.
• Use silicone to seal the gaps between
the appliances and those between the
appliances and the worktop.
• Press the rubber shape firmly against
the glass ceramic and move it slowly
along the edges to squeeze out
excess silicone.
• Put some soapy water on the silicone
and smoothen out the edges with
your finger.
• Do not touch the silicone until it
hardens, it can last for about a day.
• Carefully remove the silicone
squeeze-out with a shaving razor.
• Clean the glass surface.
ENGLISH 9