Baratza Maestro How-To page 4

Repeat until all wires are
transferred to the new
switch. Tug gently on
each wire to ensure firm
installation.
Insert the switch into
the chassis. Secure the
screw and install and
tighten the switch nut.
Re-install the PCB. Be
sure to plug the power
cord into the connector.
* The board uses Molex
connectors which are
keyed. Be aware of the
correct orientation *
Install the gearbox/motor
assembly, taking care to
keep the chute gasket in
place.
www.baratza.com
Pg. 4
Plug in
support@baratza.com
Ensure discharge
chute is aligned
with chassis
rev. 4/9/2019