Baratza Maestro How-To page 2

Pg. 2
Lift the microswitch off
of the posts.
Remove the 3 screws
T-10 or Phillips Screws
securing the gearbox/
motor assembly to the
chassis. Note: two of the
three screws may thread
into a nut.
Unplug the motor and
lift the gearbox/motor
assembly from the
chassis.
*If the motor wires are
Unplug this
attached to the circuit
board and can only be
unplugged from the
bottom of the motor,
mark which color wire
goes to each terminal
to prevent the burr from
spinning the wrong way
after reassembly (it
should spin clockwise).
www.baratza.com
support@baratza.com
rev. 4/9/2019