Switching On The Power - Yamaha SU200 Owner's Manual

• When the batteries need to be replaced, "Battry Low" may appear on the display , the volume
NOTE
may be reduced, the sound may be distorted, and other problems may occur . When this hap-
pens, turn the power off and replace the batteries.
• Even if batteries are installed, the SU200 will automatically switch to AC power when the AC
adaptor is connected.
• To conserve battery life, the display's backlight remains off when the SU200 is running on
batteries.
CAUTION
• When the batteries run down, replace them with a complete set of six new batteries.
NEVER mix old and new batteries.
• Do not use different kinds of batteries (e.g. alkaline and manganese) at the same time.
• If the instrument is not to be in use for a long time, remove the batteries from it, in order
to prevent possible leakage of battery fluid.

Switching On the Power

Z
Make the necessary connections.
Connect up headphones or an output audio device. (See page 10.)
X
Lower the volume settings on the SU200 and the audio device.
C
Press the STANDBY/ON switch to set the power ON.
The SU200 displays YAMAHA SU200 and then enters Pad-Play mode (see page 15).
CAUTION
• Note that a samll amout of current continues to flow even while the switch is in the
STANDBY position. If you are going to leave the SU200 unused for a prolonged period,
be sure to disconnect the adaptor and (if batteries are installed) remove the batteries.
V
Adjust the volume by turning the VOLUME knob.
Also adjust the volume at the external audio device.
B
When you are ready to turn off the SU200: Switch off the power to the output audio device
(or lower its volume) before switching off the SU200.
STANDBY
ON
VOLUME
13
Power connections