Starting Up - Yamaha PSR-9000 Owner's Manual

Starting Up

Check Your Power Supply
Make sure that your local AC mains voltage matches the voltage specified on the
name plate on the bottom panel. In some areas a voltage selector may be provided on
the rear panel of the PSR-9000 near the power cord. Make sure that the voltage selec-
tor is set for the voltage in your area. The voltage selector is set at 240V when the unit
is initially shipped.
To change the setting use a slotted ("minus") screwdriver to rotate the selector dial so
that the correct voltage appears next to the pointer on the panel. Make sure that the
power is turned off before changing the Voltage Selector setting.
Use the following procedure to start up the PSR-9000.
1
Make sure that the POWER switch is in the OFF (extended)
position.
2
Securely plug the "female" end of the AC power cord sup-
plied with the PSR-9000 into the rear-panel AC cord socket.
3
Plug the power cord into a convenient AC outlet.
In some areas, an AC plug adaptor may be provided to match the pin configu-
ration of the AC wall outlets in your area.
4
Turn the power ON by pressing the [POWER] switch.
Press the [POWER] switch again to turn the power OFF.
5
Play & adjust the volume.
MASTER VOLUME
MIN
14
POWER
ON OFF
MAX
Voltage Selector
AC INLET
240V
The configuration of the
AC INLET may be differ-
ent depending on your
particular locale.
WARNING
• Use only the AC power cord
supplied with the PSR-9000.
If the supplied cord is lost or
damaged and needs to be
replaced, contact your
Yamaha dealer. The use of
an inappropriate replace-
ment can pose a fire and
shock hazard!
• When turning the power OFF,
simply reverse the procedure.