Yamaha PSR-9000 Owner's Manual page 155

Full Setup
You can create your original settings and store them as a template.
Follow the on-screen instructions to call up the template display as shown below.
Assign various functions to the five
Foot Controllers.
Select the desired function to be
assigned to the selected Foot Con-
troller.
Select the desired Foot Controller.
Press the [NEXT] button to enable the selected
Easy Setup template.
Disconnect the MIDI cable from the MIDI OUT B ter-
minal and connect it to the MFC10 Foot Controller.
PAGE CONTROL
BACK NEXT
Select the destination template.
PAGE CONTROL
BACK
Store the MFC10 settings by following the
on-screen instructions.
Assign various functions to the five
Footswitches.
PAGE CONTROL
BACK NEXT
PAGE CONTROL
Select the desired Footswitch number.
BACK NEXT
NEXT
MIDI Functions
Select the desired function
to be assigned to the
selected Footswitch.
• Since all MFC10 settings data is stored to
Flash ROM, any data in the MFC10 settings
location will be erased and replaced by your
new settings. This includes the factory pro-
grammed preset MFC10 settings. If you've
deleted the factory-set data, you can use the
Restore function (page 130) to load a copy
of it from the included disks (page 6).
• When setting up the MFC10 from the PSR-
9000, a MIDI cable must be connected from
the MIDI OUT of the PSR-9000 to the MIDI
IN of the MFC10. However, you should dis-
connect this cable when using the MFC10,
since extraneous MIDI messages may be
transmitted from the PSR-9000.
• To exit from the MFC10 play mode, select
the MIDI Template display (page 150) and
press the [CANCEL] LCD button.
• The MFC10 play mode on/off status is
retained in Flash ROM and is maintained
even when the power is turned off.
Reference
155