Line Out Settings - Yamaha PSR-9000 Owner's Manual

Mixing Console

Line Out Settings

This convenient feature allows you to send the output of a selected Part or Parts to the
LINE OUT jacks.
For Drum Parts, you can even select specific drum sounds to be output through these
jacks.
In general, the extensive built-in effects and other Part controls of the PSR-9000 pro-
vide all you need for processing and mixing complex multi-Part songs. However, there
may be times (in studio recording, for instance) when you want to "sweeten" or process
a certain Voice or sound with a favorite outboard effect unit, or record a Part to a sepa-
rate track of a tape recorder. The Line Out settings are designed just for these kinds of
applications.
• When set to "MAIN," the part is output (with effects) through the MAIN LINE OUT jacks.
The sound is also output through the PSR-9000's built-in speaker system and the
PHONES jack, as well as the MAIN jacks.
• When set to one of the "SUB" settings, the Part is output through the SUB LINE OUT
jacks. In this case, only Insertion effects (DSP4 - 8 and DSP3 when this is set to Inser-
tion from the effect parameter display) can be applied; System effects (DSP1, 2 and
DSP3 when this is set to System from the effect parameter display) and MASTER EQ
cannot be applied to the SUB LINE OUT jacks.
• When set to one of the "SUB" settings, the sound of the Part will not be output through
the speaker system or the PHONES jack.
• When set to "SUB1&2," the Part is output in stereo (1: left, 2: right).
Settings of "SUB1" and "SUB2" output the Part in mono to the corresponding jack.
Parts output through the SUB LINE OUT jacks cannot be heard through the PHONES
jack and the speaker system.
126
Reference
LINE OUT
L/L + R
2 1 R
SUB MAIN
Sets the output configuration for the selected
drum sound.
An individual percussion setting overrides the Part
settings made from the display at left. When
assigned to one of the "SUB" settings, DSP
effects cannot be applied to the percussion sound.
• When using one of the "SUB"
Line Out settings, make sure
that you've connected cables
to the appropriate SUB LINE
OUT jacks on the rear panel. If
cables are only connected to
the MAIN jacks, the sound of
the Part will be output through
the MAIN jacks, even if one of
the "SUB" Line Out settings is
selected.